• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Tire Pull

W
N/A
Level: Lung

Hook a thick rope to a weighted tire, sit back into an athletic stance, and haul it across the floor hand over hand. The tire pull torches your lats, rhomboids, biceps, and forearms while keeping your core and legs under nonstop tension.

Tire

Description

Unlike a barbell row where the weight moves along a short, predictable path, pulling a heavy tire across turf or asphalt fights you with constant friction every inch of the way. There is no eccentric phase to help you bounce into the next rep. Whether you pull it hand over hand with a rope or drag it in a harness, it builds relentless pulling endurance, iron grip strength, and heavy-breathing conditioning that carries over directly to rope climbs and sled work.

In the classic hand-over-hand rope pull, you brace your feet against the floor, drop your hips into a low quarter-squat or seated anchor position, and reach forward to take the slack out of the line. Each stroke combines shoulder extension, scapular retraction, and elbow flexion as you reel the tire toward your hips. Before the tire loses momentum, your opposite hand shoots forward to grab the next section of rope and keep the rubber sliding.

Your lats, rhomboids, middle traps, rear delts, and rotator cuff muscles drive your elbows back and pull your shoulder blades together on every stroke. Your biceps, brachialis, and forearm flexors clamp onto the thick rope and bend your elbows under heavy friction. Meanwhile, your quads, hamstrings, glutes, lower back, and obliques lock your lower body and trunk in place so the tire moves toward you instead of pulling you forward.

Setup

  • Secure a thick climbing rope or tow strap around a heavy tire and walk the free end out until the line is completely taut.
  • Stand facing the tire with your feet wider than shoulder-width apart, or sit on the floor with your feet braced firmly against a heavy rig upright or bumper plates.
  • Drop your hips back and bend your knees into a low, grounded athletic stance with your weight shifted toward your heels and your chest up.
  • Grab the rope with both hands, brace your abs, and take all the slack out of the line before you start pulling.

The Pull

  1. Reach one hand far forward down the rope while keeping your lower back flat and your hips anchored low.
  2. Clamp down hard with your grip and drive your elbow straight back past your ribs, pulling the rope into your hip crease as your shoulder blade squeezes back.
  3. As that pulling hand finishes at your hip, immediately reach your other hand forward to grab the rope ahead of you.
  4. Keep alternating long, powerful hand-over-hand strokes without letting the tire come to a dead stop between pulls, since breaking static friction takes way more energy than keeping a moving tire sliding.
  5. Continue until the tire reaches your feet. If the workout combines the pull with a harness back-drag, clip the strap to your waist belt, lean back at a 45-degree angle, and march backward with short, heel-to-toe steps to reset the tire at the far line.

Breathing & Bracing

  • Keep a continuous, firm brace across your abs and obliques the entire time the tire is moving so the alternating single-arm pulls don't twist your spine.
  • Don't hold your breath during a long pull. Settle into rhythmic, forceful breathing matched to your hand strokes, exhaling sharply on your strongest pulls.
  • If you're seated and bracing your feet against a rig, keep your ribs stacked over your pelvis so your lower back doesn't round forward as you reach for the rope.

Keeping It Safe

  • Rope burn on the palms: Letting a rough manila or poly rope slide through your fingers under load will tear the skin off your hands in seconds. Always release your back hand cleanly and reach forward over the top rather than letting the rope slip through a half-open palm.
  • Lower back rounding: Reaching too far forward by folding at your waist instead of hinging at your hips puts heavy strain on your lumbar discs when you yank a dead-stop tire. Keep your chest up and let your legs and lats take the load.
  • Biceps and elbow tendonitis: Pulling purely with your arms while your shoulders stay shrugged forward will overload your elbows quickly. Initiate every single stroke by pulling your shoulder blade back and down before bending your elbow.

Common Fixes

  • Letting the tire stop between strokes: Taking slow, choppy pulls forces you to break inertia on every single hand switch, which burns your grip and lats out twice as fast. Shorten the pause between hands and keep a steady hand-over-hand cadence so the tire glides smoothly across the floor.
  • Standing too tall: As your legs get tired, your hips rise and the high angle of the rope pulls you off balance onto your toes. Drop your butt down, lean your body weight slightly back against the tension of the rope, and dig your heels into the floor.
  • Short, T-Rex arm pulls: Grabbing the rope only a few inches in front of your chest gives you zero stroke length and forces you to take double the reps. Reach your lead arm all the way out to full extension while keeping your spine flat, then pull all the way back to your hip pocket.

Scaling & Variations

  • Beginners or no tire available: Loop a battle rope through the center hole of two 45-pound bumper plates or hook it to a light prowler sled on turf to dial in the resistance smoothly.
  • Making it harder: Drop a heavy kettlebell or sandbag inside the tire cavity to increase friction, use a thicker 2-inch rope to crush your grip, or pair each seated rope pull with a heavy backward harness drag.