• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Tire Flips

W
Strongman
Level: Average

Wedge your fingers under a massive tractor tire, drive through your legs and chest to pop it upright, and shove it over onto the floor. The tire flip is a classic strongman test that builds explosive triple extension across your quads, glutes, hamstrings, back, and upper-body pushing muscles.

Tire

Description

The biggest mistake people make on the tire flip is treating it like a conventional deadlift. If you stand right over the rubber and try to pull a 300-pound tire straight up with your lower back and biceps, it's going to win every time. Instead, you lean into the sidewall at an angle and drive forward and up with your legs and hips like a football tackle, turning raw lower-body power into full-body strongman conditioning.

The movement happens in three seamless phases: the angled initial drive, the knee boost and hand transition, and the forward push. You wedge your chest into the tire and extend your hips, knees, and ankles to lever the edge off the ground. Once the tire passes your waist, you drive one knee under it, flip your hands from an underhand pull to an overhand press, and drive forward until it crashes flat.

Your quads, glutes, inner thighs, hamstrings, and calves generate the explosive forward-and-upward leg drive that breaks the tire off the floor. Your spinal erectors, lats, traps, and forearms hold your torso and grip rigid so none of that leg power leaks out. In the second half of the rep, your chest, front delts, and triceps take over to shove the standing tire past its balance point while your abs and obliques brace your trunk.

Setup

  • Step back about a foot from the base of the tire and set your feet wide, around shoulder-width or slightly wider, so your hips have room to drop.
  • Squat down and place your arms outside your knees, wedging your fingers underneath the bottom tread with a shoulder-width underhand grip.
  • Lean forward and press your chest, shoulders, and chin firmly against the sidewall of the tire. Your body should form a roughly 45-degree angle with the ground, with your weight on the balls of your feet.
  • Flatten your back, lock your elbows straight, and brace your core before you move.

The Lift

  1. Drive hard through your legs to push your chest forward and up into the tire at the same time. Don't pull up with your arms or round your lower back.
  2. Extend your hips, knees, and ankles explosively in one motion, like a power clean or a heavy sled drive, lifting the tire up toward your chest.
  3. As the bottom edge of the tire clears your waist and loses upward momentum, step one foot forward and drive your other knee up under the tire to boost it upright.
  4. Quickly flip both hands around from an underhand grip to a flat overhand pressing position against the tread, keeping your elbows tucked in.
  5. Drive forward on your feet and press hard through your palms until the tire tips past vertical and slams flat on the ground. Step right up to it and set up for the next flip.

Breathing & Bracing

  • Take a deep belly breath at the bottom and lock your abs, obliques, and lower back tight before you initiate the leg drive.
  • Hold that breath and core brace from the floor until you get your knee under the tire and switch your hands.
  • Exhale forcefully as you press the tire over the top, then take two deep recovery breaths while stepping up to the next rep.

Keeping It Safe

  • Distal biceps tendon tears: Trying to curl a heavy tire off the ground with bent arms puts massive load on your biceps tendons. Keep your elbows locked straight on the initial pull and let your legs and chest angle lever the weight up.
  • Lower back injuries: Standing too close to the tire forces your hips up early and turns the lift into a rounded-back deadlift. Set your feet back far enough that you can lean your chest into the sidewall and drive forward with your quads and glutes.
  • Crushed feet or ankles: If you stall out halfway up and lose control, a heavy tire will fall right back where it came from. Never stick your feet directly underneath a rising tire, and if a rep fails, shove yourself backward away from the rubber immediately.

Common Fixes

  • Pulling straight up like a deadlift: The tire barely budges an inch off the floor and your lower back takes all the punishment. Back your feet up six inches, glue your chest and shoulders to the rubber before you lift, and think about pushing the tire forward across the room with your legs.
  • Slow hand transition: Pausing too long at chest height lets the tire settle back down onto your wrists before you can switch to a push. Pop the tire high with your hips and a quick knee tap so it floats weightless for a split second while you spin your hands around.
  • Hands placed inside the knees: Putting your arms between your legs narrows your base and forces you to lift with your back and biceps. Always set your arms outside your knees so your thighs can drive freely without hitting your elbows.

Scaling & Variations

  • Beginners or smaller athletes: Start on a lighter 100-to-150-pound tire to master the chest lean and hand transition, or team up with a partner to do two-person synchronized tire flips.
  • Making it harder: Move up to a 300-to-500-pound tractor tire, or perform a "flip and jump" conditioning drill where you jump into the center of the tire and jump out the far side after every single flip.