• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Squat Jerk

W
Jerk
Level: Technically Complex

Dip and drive a barbell off your shoulders, then drop straight into a full overhead squat to catch the weight at the bottom before standing tall. The squat jerk is a technical weightlifting variation that demands elite ankle, hip, and thoracic mobility alongside massive quad, glute, and shoulder strength.

Barbell

Description

Made famous by elite Chinese weightlifters, the squat jerk is the flashiest and most unforgiving way to put a barbell overhead. Instead of splitting your feet forward and back like a split jerk, you keep your feet in your squat stance and drop all the way into a full squat to receive the bar. Because you catch the bar much lower, you technically don't have to drive it as high, but standing up out of the hole with a maximal clean weight locked over your head requires unreal mobility and leg strength.

The movement starts identically to a push jerk or split jerk with a short, vertical dip and an explosive upward drive through the heels. As the bar leaves your shoulders at the peak of triple extension, you push yourself aggressively down under the bar into a deep overhead squat while locking your elbows out. Once you stabilize the bar directly over the middle of your feet in the hole, you drive through the floor to stand all the way up.

Your quads and glutes do double duty, first launching the bar off your collarbones during the drive and then squatting the weight up out of the deep bottom catch. Your calves assist in the explosive ankle extension, while your traps, side delts, serratus anterior, and triceps lock the bar overhead with a narrow clean-width grip. Meanwhile, your upper back, lats, abs, and obliques work furiously to keep your torso upright in the bottom of the squat.

Setup

  • Take the barbell from a rack or clean it onto your front rack shelf across your collarbones and front delts, keeping your hands just outside your shoulders.
  • Set your feet in your pulling or squatting stance (between hip-width and shoulder-width apart) with your toes turned out 15 to 30 degrees.
  • Lift your elbows slightly so the bar rests securely on your shoulders, brace your core 360 degrees, and stack your ribs directly over your pelvis.
  • Pull your chin back slightly so the bar has a clear vertical path past your nose, and look straight ahead.

The Lift

  1. Dip straight down 3 to 4 inches by bending your knees forward over your toes while keeping your torso completely vertical and your heels glued to the floor.
  2. Reverse direction instantly without pausing at the bottom of the dip, driving violently through your heels and midfoot to extend your knees, hips, and ankles.
  3. As the bar floats off your shoulders, slide or hop your feet slightly wider into your squat stance and pull yourself straight down under the bar.
  4. Punch your hands hard into the bar to lock out your elbows at the exact moment you hit the bottom of a full squat (hip crease below the knees), holding the bar stacked over the back of your neck and midfoot.
  5. Settle the bar for a split second at the bottom if needed, then drive hard through your heels to stand all the way up with your hips, knees, and elbows locked out.

Breathing & Bracing

  • Take a deep belly breath at the top before you dip, expanding your midsection 360 degrees like an inflated tire.
  • Hold that breath through the dip, drive, and drop into the full squat, keeping your brace rock-solid as you fight out of the bottom.
  • Exhale only after you pass the sticking point on the way up or once you lock the bar out at the top.

Keeping It Safe

  • Shoulder and wrist overload: Catching a bar overhead in a deep squat with a narrow clean-width grip puts extreme mobility demands on your thoracic spine and shoulders. If you can't overhead squat a bar comfortably with a clean grip, stick to power jerks or split jerks until your mobility catches up.
  • Dumping the bar forward or backward: Even a half-inch forward lean in the hole will send the bar crashing in front of you. Always train on an open lifting platform with bumper plates, and practice how to safely push away from a missed bar.
  • Knee and lower back strain: Crashing into the bottom of the catch with relaxed legs bounces your knees and rounds your lower back under load. Stay active in your quads and upper back as you pull yourself down into the hole.

Common Fixes

  • Dipping forward onto the toes: Letting your chest pitch forward during the dip kicks the bar out in front of your face, making it nearly impossible to save in a narrow-grip squat. Imagine sliding your back down a flat wall during the dip.
  • Pressing the bar up instead of dropping under: Trying to push-press the weight overhead and then squatting down slowly turns it into two separate exercises. Use the legs to get the bar moving, then focus on speed under the bar.
  • Narrow grip pinching the shoulders at the bottom: If your upper back rounds in the hole with your regular clean grip, widen your hands by one or two finger-widths during your clean setup or when taking the bar from the rack.

Scaling & Variations

  • Mobility limitations or learning the timing: Practice power jerks (catching above parallel) followed by a controlled overhead squat with a clean-width grip, or drill behind-the-neck drop snatch balances with an empty bar.
  • Making it harder: Add a 2-second pause in the bottom of the squat jerk before standing up, or perform clean and squat jerk complexes at 70 to 80 percent to test your leg stamina.