• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Squat Cleans (SC)

W
Cleans
Level: Technically Complex
Abbreviation: SC

The squat clean takes a loaded barbell from the floor and catches it on your front shoulders in the bottom of a deep front squat before standing to full lockout. It builds explosive hip power, front-rack stability, and heavy leg strength across your quads, glutes, traps, and core.

Barbell, Barbell plate

Description

In both Olympic weightlifting and CrossFit, the squat clean is the king of moving heavy weight from the ground to the shoulders. You can muscle up a sloppy power clean when the bar is light, but once the load gets heavy, you have to pull yourself down into a full squat to meet the bar low. Mastering the timing of the pull and the turnover carries directly over to thrusters, clusters, and heavy clean and jerks.

Mechanically, the lift breaks down into three seamless phases: the first pull off the floor, the explosive second pull from mid-thigh, and the third pull where you actively pull your body under the bar into a front squat. As you drive your legs into the floor and snap your hips open, the bar accelerates vertically close to your torso. At peak extension, you whip your elbows forward and around the bar, catching it on your front deltoids in the hole and riding the bounce right back up.

Your quads, glutes, and traps generate the main upward drive and stand the weight out of the bottom. Your hamstrings, inner thighs (adductors), calves, lower back, and shoulders support the pull from the floor and keep your posture upright in the catch. Meanwhile, your abs, obliques, lats, and forearms lock your trunk rigid and keep the bar tracking tight against your thighs.

Setup

  • Stand with your feet hip-width apart and the barbell directly over the balls of your feet, about an inch from your shins.
  • Squat down and grip the bar just outside your legs using a hook grip (thumbs wrapped under your index and middle fingers).
  • Set your hips higher than your knees and lower than your shoulders, with your back flat, chest up, and shoulders positioned slightly in front of the bar.
  • Pull the slack out of the bar, sweep the bar back with your lats, and look straight ahead.

The Lift

  1. Drive your feet through the floor to lift the bar smoothly past your shins and knees while keeping your back angle constant and your arms completely straight.
  2. As the bar passes your knees, sweep it back into your mid-to-upper thighs while shifting your torso upright to load your hips and hamstrings.
  3. Drive aggressively through the floor and snap your hips, knees, and ankles into full triple extension while shrugging your shoulders hard. Do not bend your arms early to pull the bar.
  4. The instant your hips finish extending, shuffle your feet out to your squat stance, pull your body rapidly under the bar, and whip your elbows fast and high around the bar.
  5. Catch the bar across your front shoulders in the bottom of a full squat with your hip crease clearly below your knees, then drive straight out of the hole to full hip and knee extension with your elbows still up. Catching above parallel without squatting below your knees is a power clean, not a squat clean.

Breathing & Bracing

  • Take a deep belly breath during your setup on the floor and lock in a tight 360-degree core brace before the plates leave the ground.
  • Hold that breath through the pull, the extension, and the impact of the catch in the hole so the bar doesn't fold your chest forward.
  • Exhale as you drive past the sticking point on the way up from the front squat.

Keeping It Safe

  • Wrist and elbow hyperextension: Catching a heavy bar with low elbows dumps the weight straight onto your wrists and can slam your elbows into your knees in the hole. Keep a loose fingertip rack at the catch and drive your elbows high so your shoulders carry the bar, not your wrists.
  • Lower back rounding in the hole: Losing midline tension or catching the bar two inches out in front of your shoulders will pull your upper back over and strain your lower back. Keep the bar close during the pull and fight for a vertical chest the moment your feet land.
  • Collarbone bruising: Letting the bar crash down onto you because you stopped pulling under it will leave your collarbones battered. Meet the bar smoothly by actively pulling yourself down and raising your shoulders into a muscular shelf.

Common Fixes

  • Early arm bend: Bending your elbows off the floor leaks power from your hips and slows down your turnover. Think of your arms as ropes or chains until your hips pop open at mid-thigh.
  • Bouncing the bar off the hips: Smashing your pelvis forward into the bar loops it out in front of you and forces you to jump forward to save it. Drive vertically through your legs and brush the bar upward along your thighs instead of banging it away.
  • Slow elbows in the turnover: Floating to the bottom with your elbows pointing down makes you lose the bar off the front of your shoulders. Drill tall muscle cleans and high-hang squat cleans in your warm-up to train fast, snappy elbows.

Scaling & Variations

  • New lifters or tight front racks: Start with hang squat cleans from above the knee to simplify the pull off the floor, or use two dumbbells if wrist and shoulder tightness prevents a clean barbell front rack.
  • Breaking plateaus: Add pause squat cleans (stopping for 2 seconds at the knee during the pull, or pausing 2 seconds in the hole before standing) to build positional strength and bottom-end confidence.