• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Sledge Hammer Strikes

M
N/A
Level: Lung

Grab a heavy sledgehammer, swing it overhead in a tight arc, and drive it down into a tractor tire. It's raw full-body conditioning. Every strike taxes your lats, shoulders, forearms, and rotational core while driving your heart rate up fast.

Hammer

Description

Sledgehammer strikes have been a staple for fighters and old-school conditioning for decades, and they fit right into tough CrossFit metcons. Swinging a long lever with a heavy steel head at the end demands full-body coordination rather than isolated muscle strength. You build crushing grip endurance, rotational trunk power, and work capacity that carries over to everything from chopping wood to heavy rope climbs and toes-to-bar.

Each swing combines a diagonal overhead arc with an explosive hip hinge. As you bring the hammer up and behind your shoulder, your torso rotates and your top hand slides down the handle during the downswing. At the top of the arc, you snap your hips back and pull the handle down hard toward the tire, turning your whole body into a whip before using the tire's natural bounce to reset for the next rep.

Your lats, chest, shoulders, and triceps generate the downward speed to accelerate the hammerhead toward the rubber. Your forearms and wrist flexors clamp down on the handle to control the impact and rebound. At the same time, your obliques and rectus abdominis fire hard to snap your ribcage down, while your glutes, hamstrings, and lower back anchor your lower body to the floor.

Setup

  • Stand about two feet away from a heavy flat-lying tractor tire with your feet slightly wider than shoulder-width apart.
  • Stagger your stance by placing your left foot a few inches ahead of your right if you're swinging over your right shoulder, or reverse your feet for the left side.
  • Grip the very bottom knob of the handle with your lead hand (left hand if your left foot is forward) and place your other hand high up near the steel head.
  • Soften your knees, brace your abs, and keep your eyes locked on the exact spot on the tire wall you plan to hit.

The Movement

  1. Sweep the hammerhead out to the side, up, and back over your rear shoulder in a smooth diagonal arc while rotating your torso slightly toward that side.
  2. Let your knees bend slightly and load your hips as the hammer reaches its highest point behind your shoulder.
  3. Initiate the strike by snapping your hips back and pulling down hard with your lats and abs, sliding your top hand down the shaft until it meets your bottom hand.
  4. Smash the center of the tire wall with both hands together near the base of the handle, finishing in a strong athletic hinge with a flat back.
  5. Let the hammer rebound off the rubber and slide your top hand right back up toward the steel head to control the bounce and guide it into the next swing. Switch your stance and lead hand halfway through the set so both sides get equal work.

Breathing & Bracing

  • Inhale deeply as you swing the hammer up and load it behind your shoulder.
  • Brace your abs and obliques hard right before you start the downswing so your spine stays safe under the long lever arm.
  • Exhale sharply on impact, just like throwing a punch, to maximize downward force and keep your breathing rhythm steady during long sets.

Keeping It Safe

  • Shin and foot strikes: Missing the tire or glancing off a wet edge can send a 16-pound steel head swinging right between your legs. Always stand wide enough and far enough back that a missed swing passes harmlessly into the floor ahead of your toes, and never hit the rounded sidewall edge.
  • Elbow and wrist joint shock: Death-gripping the handle with both hands separated at the moment of impact transfers violent vibration straight into your elbows. Slide your top hand down to meet your bottom hand before impact, and loosen your fingers slightly right as the head hits the rubber so the handle doesn't sting your palms.
  • Lower back strain: Rounding your lumbar spine at the bottom of the swing or muscling a heavy hammer back up with a twisted back will light up your erectors. Hinge at your hips instead of folding at your waist, and use the tire's natural bounce to help lift the hammer.

Common Fixes

  • Fighting the slide: Keeping your top hand glued near the hammerhead the whole way down cuts your leverage in half and makes the swing choppy. Practice sliding your top hand smoothly down the handle on the downswing and sliding it back up on the rebound.
  • All-arm chopping: Standing tall with stiff legs and trying to swing the hammer using only your shoulders and triceps will gas your arms out in thirty seconds. Sit your hips back aggressively as the hammer comes down so your body weight and core drive the strike.
  • Only swinging over one shoulder: Everyone has a dominant side, and sticking to it builds lopsided obliques and tight shoulders. Alternate your foot stance and hand placement every 10 to 15 reps, or practice continuous figure-eight switches on every strike.

Scaling & Variations

  • Beginners or grip fatigue: Start with an 8-pound or 10-pound hammer, or swap to medicine ball slams on the floor to groove the overhead hinge pattern without worrying about a long handle or dangerous rebound.
  • Making it harder: Move up to a 16-pound or 20-pound sledgehammer, or perform alternating shoulder strikes where you switch your top and bottom hands in midair on every single bounce.