• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Ring L-Sit

G
Static
Level: Average

The ring L-sit is a brutal gymnastics hold that tests your upper-body stability and midline strength at the same time. Supporting yourself on unstable rings with your legs locked out parallel to the floor lights up your abs, hip flexors, quads, and triceps while building rock-solid shoulder control.

Gymnastic rings

Description

Holding a clean L-sit on solid bars is hard enough. Taking that same shape onto gymnastics rings turns a simple static hold into a full-body shaking match. It builds the straight-arm shoulder stability and midline compression you need for strict ring muscle-ups, ring dips, and clean inversions.

Your shoulders, chest, and triceps fight to keep the straps still while your torso stays vertical and your legs float straight out at a 90-degree angle. Because the rings want to swing out in every direction, you have to push straight down into the handles and pack your shoulder blades down away from your ears. Your hips shift back slightly between the straps to balance your center of mass.

Your rectus abdominis, obliques, and deep core muscles lock your pelvis in place so your lower back doesn't arch. Down below, your hip flexors and quads work overtime to keep your knees completely straight and your heels lifted to hip height. Meanwhile, your triceps, delts, chest, lats, and forearm flexors clamp the rings tightly against your sides to stop the wobble.

Setup

  • Set the rings around chest or hip height so your feet hang clear of the floor when you jump to support.
  • Grip the bottoms of the rings firmly with neutral wrists and jump up into a locked-out support position.
  • Press hard down into the rings to push your shoulders away from your ears, keeping your elbows completely straight and the rings tucked close to your hips.
  • Squeeze your legs together, lock your knees, and look straight ahead.

The Hold

  1. Take a quick breath, brace your stomach, and lift both legs smoothly in front of you without swinging or kicking up for momentum.
  2. Raise your feet until your legs are completely parallel to the floor, forming a clean 90-degree L-shape with your torso.
  3. Point your toes forward and squeeze your quads hard so your knees don't bend.
  4. Keep pressing your shoulders down into the rings with your arms locked out and your chest proud. If your heels drop below hip level or your knees bend, the clock stops.
  5. Hold the position for your target time, then lower your legs back down under control before stepping off the rings.

Breathing & Bracing

  • Locking your breath makes you red-line in five seconds. Instead, take short, shallow breaths behind a tight abdominal wall while keeping your ribs pulled down.
  • Brace your core 360 degrees as if someone is about to tap your stomach, keeping constant pressure through your abs and obliques the entire hold.
  • In timed workouts where you accumulate seconds, rest 10 to 15 seconds between sets so your breath and shoulder stability don't fall apart.

Keeping It Safe

  • Shoulder impingement: Letting your shoulders shrug up to your ears while hanging in the straps pinches the tendons in the front of your shoulder. Always push the rings down actively and stop the set the second your shoulders start sinking.
  • Elbow tendon strain: Unstable rings put heavy stress on your biceps tendons and inner elbows if you aren't used to straight-arm support. Build 30-second plain ring supports before trying to lift your legs into a full L-sit.
  • Hip flexor cramping: Tight quads and weak hip flexors will cramp up almost immediately when you try to hold straight legs at 90 degrees. Roll out your quads and warm up with seated leg lifts on the floor before jumping on the rings.

Common Fixes

  • Swinging into the hold: Kicking your legs up uses momentum and sends the rings swinging wildly. Lift your legs slowly over a 2-second count so you stay balanced right between the straps.
  • Bent knees and dropping heels: Your hip flexors fatigue first, causing your knees to sag and your feet to dip toward the floor. Squeeze your quads as hard as you can and point your toes to lock your knees straight.
  • Rings flaring out wide: When your chest and lats get tired, your arms drift away from your body and you lose leverage. Pin your upper arms tight against your ribs like you're holding rolled-up newspapers under your armpits.

Scaling & Variations

  • Building the strength: Start with a plain ring support hold with your feet hanging down, or hold a single-leg ring L-sit by extending one leg while keeping the other knee tucked. You can also practice L-sits on stable dip bars or floor parallettes first.
  • Making it harder: Turn the rings out 45 degrees at the top of the support while holding the L-sit, or wear light ankle weights to torture your abs and hip flexors.