• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

One arm Kettlebell press

W
Presses
Level: Average

Clean a kettlebell to your shoulder, brace your body from the floor up, and press the weight straight overhead with one arm and zero leg drive. The one-arm kettlebell press builds raw shoulder and triceps strength while forcing your core and upper back to stabilize an offset load.

Kettlebell

Description

Pressing a dumbbell or barbell lets the weight sit balanced right in the middle of your palm. A kettlebell hangs behind your wrist, pulling your arm backward and outward the entire way up. Because you have to press with one arm while standing tall without any dip from your knees, the one-arm kettlebell press builds bulletproof shoulders and serious anti-flexion trunk strength.

Every rep starts from a tight front rack with your thumb near your collarbone and the bell resting gently in the V formed by your forearm and biceps. As you press, your forearm drives vertically while your shoulder blade rotates upward smoothly along your ribcage. At the top, the kettlebell finishes stacked directly over your shoulder, hip, and midfoot with your biceps right next to your ear.

Your front and side delts work alongside your supraspinatus and upper chest to drive the bell off your shoulder. Your triceps take over through the middle of the lift to lock out your elbow. Meanwhile, your lats, traps, rhomboids, serratus anterior, abs, obliques, and glutes fire hard to keep your spine vertical and stop the heavy bell from tipping you sideways.

Setup

  • Clean a kettlebell into a clean rack position on one side, resting the bell against the outside of your forearm and biceps with your elbow tucked near your ribs.
  • Keep your wrist completely straight like you're about to punch the ceiling, never letting the weight bend your hand backward.
  • Set your feet between hip-width and shoulder-width apart with your weight planted evenly across both heels and midfeet.
  • Squeeze your glutes and quads hard, brace your abs, and tense your free arm out to the side or in a fist to create full-body tension.

The Press

  1. Pull your lats tight under your working arm to create a solid launchpad, then press the kettlebell straight up off your shoulder without dipping your knees.
  2. Let your forearm rotate naturally from facing inward at the rack to facing forward as the bell rises, keeping your elbow tracking along a natural 45-degree angle rather than flared straight out.
  3. Drive the weight vertically past your face without leaning your torso excessively to the opposite side.
  4. Punch straight up into a crisp overhead lockout with your elbow locked, biceps by your ear, and shoulder packed smoothly in its socket. Bending your knees to push press the weight or finishing with a bent elbow is a no-rep.
  5. Pull the kettlebell back down into the rack position under full control using your lats, pause for a second, and start the next rep.

Breathing & Bracing

  • Take a sharp breath into your belly at the rack position and lock your abs, obliques, and glutes into a rigid 360-degree brace.
  • Hold that breath through the bottom half of the press, or hiss air out through clenched teeth as you push through the sticking point.
  • Inhale again as you pull the bell back down into the front rack so your torso stays pressurized under the weight.

Keeping It Safe

  • Wrist hyperextension: Letting the handle sit high in your fingers bends your wrist back and strains your tendons under load. Wedge the handle diagonally across the heel of your palm so your knuckles point straight up.
  • Lower back arching: Leaning backward to turn a heavy overhead press into a standing incline bench press jams your lumbar spine. Squeeze your glutes as hard as you can and keep your ribs stacked down over your pelvis.
  • Shoulder pinching: Flaring your elbow straight out to the side from the very start of the press can irritate your rotator cuff. Start with your elbow tucked near your ribs and let it track slightly forward and out as you press.

Common Fixes

  • Leaning sideways away from the bell: When the weight gets heavy, athletes side-bend to get under the bell instead of pressing it. Drop the weight by 4 kilograms and focus on keeping both shoulders level until the last few inches of lockout.
  • Losing tension on the descent: Letting the bell crash back onto your collarbone wastes eccentric strength and beats up your shoulder. Actively pull the bell down into the rack as if you're doing a single-arm lat pulldown.
  • Soft legs and loose glutes: Pressing from a relaxed lower body leaks force into the floor. Root your feet into the rubber and lock your quads and glutes before the bell leaves your rack.

Scaling & Variations

  • Building strict strength: Start with a lighter kettlebell or a single dumbbell if the offset kettlebell rack bothers your forearm, or use a slight leg dip (push press) to get the weight overhead and lower it on a 4-second strict negative.
  • Making it harder: Perform strict bottoms-up kettlebell presses (holding the bell upside down by the horn) to demand extreme grip and shoulder stability, or do seated Z-presses on the floor with straight legs.