• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Kettlebell Push Jerks

W
Jerk, Push
Level: Average

The kettlebell push jerk uses a fast leg drive and a quick second dip to launch one or two kettlebells from the front rack to a locked-out overhead position. By dropping under the weight instead of muscling it up, your quads, glutes, shoulders, and triceps can cycle heavy bells for high reps.

Kettlebell

Description

When a kettlebell gets too heavy to strict press and your shoulders start burning on push presses, the kettlebell push jerk keeps you moving. It is a bread-and-butter lift in kettlebell sport (long cycle and jerk events) and a great unilateral or bilateral tool in CrossFit workouts. Because you use your legs twice, once to launch the bell and once to duck underneath it, your shoulders save tons of energy over long sets.

The lift starts with the kettlebell nestled securely in the front rack. You dip a few inches with an upright torso, drive hard through the floor to send the bell flying upward, and then immediately drop back into a quarter squat while punching your hand straight to the ceiling. Once your elbow is locked out and the weight is stacked over your shoulder, you stand up to finish the rep.

Your quads, glutes, and calves do the heavy work during the initial drive and catch the load in the second dip. Up top, your shoulders, triceps, upper chest, and serratus punch the bell into lockout and hold it steady. Meanwhile, your abs, obliques, lats, and lower back brace hard to keep your torso from twisting or leaning away from a single kettlebell.

Setup

  • Clean one or two kettlebells into a solid front-rack position with your feet set between hip-width and shoulder-width apart.
  • Slip your hand deep through the handle so it rests diagonally across the base of your palm, keeping your wrist completely straight and the bell resting between your forearm and biceps.
  • Tuck your elbow down against your ribs or hip crest so your torso supports the weight rather than just your arm.
  • Brace your abs, squeeze your glutes, and look straight ahead.

The Lift

  1. Dip 3 to 4 inches straight down by bending your knees while keeping your heels flat on the floor and your elbow connected to your torso.
  2. Drive explosively through your heels and midfoot to extend your hips and knees, launching the kettlebell upward off your chest.
  3. The split second your legs finish extending, drop your hips and knees back down into a fast quarter squat while punching your arm straight up to full lockout.
  4. Catch the kettlebell overhead with a completely locked elbow, a straight wrist, and your biceps right next to your ear before your hips stop moving down.
  5. Stand all the way up to lock out your knees and hips with the weight stabilized overhead, then lower the bell smoothly back into the front rack while bending your knees slightly to absorb the catch.

Breathing & Bracing

  • Take a quick breath in as the bell settles into the rack and brace your core 360 degrees before starting your dip.
  • Let out a short, sharp exhale as you drive and punch under the bell, keeping your abs tight so your ribs don't flare on the catch.
  • Take another quick breath at the top lockout before absorbing the bell back down into the rack.

Keeping It Safe

  • Forearm and wrist banging: If the kettlebell flips over the top of your hand and slams onto your forearm, you're gripping the top of the handle like a dumbbell. Slide your hand through the corner of the handle and punch straight up at the top rather than letting the bell arc outward.
  • Lower back pain: Leaning backward in the rack or arching your lower back at overhead lockout puts heavy strain on your spine. Squeeze your glutes during the drive and keep your ribs stacked over your hips in the catch.
  • Shoulder fatigue and instability: Catching a heavy bell with a soft elbow lets the weight pull your arm backward. If you can't lock your elbow out cleanly on the catch, drop down to a lighter kettlebell.

Common Fixes

  • Turning it into a push press: Many athletes dip and drive, then keep their legs straight while pressing the bell the rest of the way up. Practice stamping your heels into the floor as your elbow locks out to drill the second knee bend.
  • Elbow disconnecting during the dip: Letting your elbow float away from your ribs in the dip wastes your leg drive. Keep your upper arm glued to your torso until your legs launch the bell.
  • Pressing out in front: If the kettlebell finishes out in front of your forehead, it will pull you forward onto your toes. Push your head slightly through at the catch so the bell sits directly over the back of your shoulder and midfoot.

Scaling & Variations

  • Beginners or tight overhead mobility: Start with a single light kettlebell push press to learn the vertical dip and drive before adding the second dip under the bell, or use a dumbbell if the kettlebell handle bothers your forearm.
  • Making it harder: Run double-kettlebell push jerks to double the load on your legs and core, or add a 2-second pause in the quarter-squat catch position to drill rock-solid overhead balance.