• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Kettlebell Goblet Thruster

W
Thruster
Level: Lung

The kettlebell goblet thruster combines a deep goblet squat with a fast overhead press in one smooth motion. Holding a single kettlebell at your chest, you squat below parallel and use your leg drive to punch the weight overhead, smoking your quads, glutes, shoulders, and lungs.

Kettlebell

Description

Barbell thrusters get all the glory, but the kettlebell goblet thruster is one of the best conditioning tools in the gym. Holding a single bell in front of your chest lets you sit more upright than a barbell allows, making it friendlier on tight wrists and stiff shoulders. Don't let that fool you. A long set of these will blow up your legs and breathing just as fast as Fran.

The movement links two halves into one fluid transfer of force. You control the kettlebell down into a full squat, keeping the bell tucked tight against your chest so it doesn't pull you forward. On the way up, you drive hard with your legs and transfer that upward momentum straight into the kettlebell, finishing the rep with a fast arm press.

Your quads and glutes power you out of the squat, while your shoulders, upper chest, and triceps lock the weight out overhead. Down at the bottom, your hamstrings and inner thighs (adductors) help reverse the load, and your upper back and serratus stabilize your shoulder blades as the bell goes up. Meanwhile, your abs, obliques, and lower back work overtime to keep your ribs down and your spine flat from the hole to lockout.

Setup

  • Stand with your feet around shoulder-width apart and toes turned out 10 to 25 degrees.
  • Clean or deadlift a single kettlebell up to chest height, holding it by the horns (sides of the handle) or upside-down by the bell housing.
  • Tuck your elbows in and point them slightly down so your forearms stay nearly vertical and the bell sits close to your sternum.
  • Brace your abs, squeeze your glutes, and look straight ahead.

The Lift

  1. Break at your hips and knees together, sitting your hips down between your heels while keeping your chest tall and the kettlebell right at your collarbone.
  2. Push your knees out over your toes until your hip crease drops clearly below the top of your kneecap. Stopping high is a no-rep.
  3. Drive hard through your heels and midfoot to accelerate out of the bottom, keeping your elbows up so your torso doesn't tip forward.
  4. As your hips and knees snap to full extension, ride that leg drive and press the kettlebell straight up overhead in one unbroken motion.
  5. Lock out your elbows completely with the kettlebell stacked directly over your shoulders, hips, and heels, then lower it back to your chest as you descend into the next squat.

Breathing & Bracing

  • Take a full breath in at the top or as you pull the bell down to your chest, locking in a 360-degree brace before you drop into the squat.
  • Hold your air through the bottom turnaround so your torso stays rigid and transfers all your leg power into the bell.
  • Exhale forcefully as the kettlebell passes your forehead on the press, then take a fresh breath at lockout before the next rep.

Keeping It Safe

  • Lower back strain: Happens when you let your elbows drop in the squat or arch your back to press a heavy bell overhead. Keep the kettlebell glued to your chest on the way down and squeeze your glutes hard at the top so your lower back doesn't hyperextend.
  • Wrist and forearm bruising: Holding the bell loosely lets it shift and bang against your wrists. Grip the horns tightly with straight wrists, as if you're trying to bend the handle in half.
  • Shoulder pinching: Pressing the weight out in front of your face instead of straight overhead strains the front of your shoulder. Push your head slightly through your arms ("through the window") at the top so your biceps finish right by your ears.

Common Fixes

  • Pressing too early: Starting your arm press while you're still halfway up the squat kills your leg drive and fries your shoulders. Wait until your hips and knees almost finish extending before you punch with your arms.
  • Pausing at the standing position: Stopping at the top of the squat turns the rep into a goblet squat plus a strict press. Think of the top 6 inches of the squat as a launchpad and fire the bell up without a hitch.
  • Letting the bell pull you onto your toes: When your weight shifts forward, your heels pop up and your knees take a beating. Sit your hips down between your heels and keep your whole foot flat on the rubber.

Scaling & Variations

  • Beginners or shoulder limitations: Drop down to a lighter kettlebell, or split the movement into goblet squats only if overhead pressing causes pain. You can also squat to a parallel box to dial in your depth.
  • Making it harder: Grab a heavier kettlebell, hold the bell bottoms-up to test your grip and shoulder stability, or move up to double-kettlebell front-rack thrusters.