• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Jumping Chest To Bar Pull-Up

G
Jumps, Pull-up
Level: Lung

Stand under a low bar or on a plyo box, use a controlled leg drive to jump up, and pull hard with your lats and arms until your chest touches the bar. Jumping chest-to-bar pull-ups build pulling volume, top-end lockout strength, and conditioning when strict or kipping chest-to-bar reps aren't quite there yet.

Pull-up bar, Racks

Description

Getting your chin over the bar is one thing, but pulling the bar all the way down to your sternum takes a lot more lat, upper-back, and bicep strength. The jumping chest-to-bar pull-up bridges that gap. By using just enough leg drive to help you through the bottom half of the pull, you can train that tough final few inches where your elbows drive back and your chest meets the steel, all while keeping your heart rate high in fast conditioning workouts.

This movement combines a vertical jump from your lower body with a full-range vertical pull from your upper body. Starting from a quarter-squat with your arms fully extended overhead, your legs push into the floor or box while your lats, upper back, and arms pull simultaneously to bring your collarbone and chest into contact with the bar. Lowering yourself back down under control gives you an extra dose of eccentric pulling strength on every single rep.

Your lats, rhomboids, traps, rear delts, and biceps do the upper-body pulling work to close the gap and bring your chest to the bar, while your forearms and wrist flexors lock your grip. Down below, your quads, glutes, and calves provide the assisting upward boost from the floor or box. Meanwhile, your abs and obliques keep your ribcage and pelvis connected so your body moves as one tight unit.

Setup

  • Set up under a low pull-up bar or stand on a stable plyo box or stack of bumper plates so the bar sits roughly 4 to 6 inches above your wrists when you reach straight overhead.
  • Grip the bar slightly wider than shoulder-width apart with an overhand grip and your thumbs wrapped securely around the steel.
  • Bend your knees and hips into a partial squat until your elbows are completely locked out at the bottom while your feet stay flat on the box or floor.
  • Pack your shoulders slightly down away from your ears, brace your abs, and look up toward the bar.

The Pull-Up

  1. From the bottom squat position with straight arms, drive through your feet and pull hard with your lats and arms at the exact same time.
  2. Drive your elbows down and back behind your ribs rather than just pulling straight down to your sides.
  3. Pull until your chest clearly makes physical contact with the bar anywhere below your collarbone. Stopping at chin height is a no-rep for chest-to-bar standards.
  4. Control your body on the way back down, extending your elbows completely while bending your knees to return to the starting squat position.
  5. In strength-building sets, take 2 to 3 seconds lowering yourself down to work your lats. In fast metcons, cycle straight into the next jump as soon as your arms hit full extension at the bottom.

Breathing & Bracing

  • Inhale as you lower down into the bottom squat position with your arms extended.
  • Exhale sharply as you jump and drive your chest into the bar, keeping your abs braced so your lower back doesn't overarch at the top.

Keeping It Safe

  • Bruising your sternum: Jumping too hard with your legs and slamming your chest into the steel bar leaves nasty bruises on your breastbone. Use just enough leg assistance to reach the bar smoothly, and let your upper back pull you into controlled contact.
  • Missing the box on the way down: When you're breathing hard in a workout, taking your eyes off your feet while standing on a narrow box can lead to a twisted ankle or shin scrape. Keep your feet planted in the center of a wide, stable box or stack of wide 45-pound plates so they never leave the surface much.
  • Elbow and shoulder strain: Dropping into a relaxed, dead hang at the bottom with zero control yanks on your shoulder capsules and bicep tendons. Keep active tension in your shoulders and let your legs absorb the landing smoothly as your arms straighten.

Common Fixes

  • Doing 95 percent legs and 5 percent arms: If the box is set too high, you end up just jumping to the bar without pulling at all. Lower the box by 2 to 4 inches so your lats and biceps actually have to fight for the top few inches.
  • Reaching with the chin instead of the chest: Craning your neck up doesn't count as a chest-to-bar rep and leaves your shoulders rounded forward. Pull your shoulder blades together and drive your elbows back behind your torso so your sternum rises to the bar.
  • Cutting the bottom range of motion: Starting the next jump with bent elbows cheats the bottom half of the pull and gets no-repped by judges. Drop your hips low enough at the bottom of every rep to lock your elbows out completely.

Scaling & Variations

  • Easier option: Perform regular jumping chin-over-bar pull-ups, or switch to steep ring rows where you pull the rings all the way to the sides of your chest.
  • Making it harder: Jump up to touch your chest to the bar, lift your feet off the box, and lower yourself down in a strict 4-second negative, or move on to band-assisted and kipping chest-to-bar pull-ups.