• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Dumbbell Hang Clean and Jerks

W
Cleans, Jerk
Level: Technically Complex

Swing a pair of dumbbells from between your knees or outside your thighs, pop your hips to rack them on your shoulders, and drive them overhead in a crisp dip and punch. Dumbbell hang clean and jerks build explosive hip power, unilateral shoulder stability, and serious conditioning across your quads, glutes, back, and shoulders.

Dumbbell

Description

When a workout calls for high-rep weightlifting cycling without the rigid grip of a barbell, dumbbell hang clean and jerks take center stage. Because you start each rep from the hang above the floor, you can move at a blistering pace while saving your lower back from the extra range of motion of pulling off the ground. At the same time, handling two independent dumbbells forces both sides of your body to do equal work and demands way more shoulder stabilizer control overhead than a barbell ever will.

The movement flows through two explosive hip drives per rep. First, you hinge or swing the dumbbells to your knees, snap your hips open to float the bells onto your shoulders in a partial squat, and stand tall. Right from there, you dip straight down a few inches, drive hard with your legs, and drop under the dumbbells to lock both arms out overhead before standing to finish the rep.

Your quads and glutes drive both the hang clean and the jerk, while your hamstrings, inner thighs, and calves help snap your hips and ankles into extension. Your traps, upper back, forearms, and biceps guide the dumbbells up to your shoulders, and your delts, upper chest, and triceps lock the weights out overhead. Through every rep, your abs, obliques, and spinal erectors brace hard to keep your torso upright.

Setup

  • Dead-lift the dumbbells from the floor with a flat back and stand tall to establish the hang position before your first rep begins.
  • Set your feet between hip-width and shoulder-width apart if you're swinging the dumbbells outside your legs, or slightly wider than shoulder-width if you prefer swinging them between your knees like kettlebells.
  • Hold the dumbbells with a neutral grip (palms facing in), pull your shoulder blades back, and brace your core.
  • Look straight ahead and keep your weight balanced across your midfoot and heels.

The Lift

  1. Hinge at your hips and bend your knees slightly to lower the dumbbells to hang height (above or just below your knees), keeping your back flat and chest up.
  2. Drive your feet into the floor and snap your hips and knees open violently while shrugging your shoulders.
  3. Pull your elbows through fast and drop into a strong quarter-squat to catch the back heads of both dumbbells resting on your shoulders, then stand up (or flow straight into your jerk dip if cycling fast).
  4. With your torso vertical and heels planted, dip straight down 3 to 4 inches and drive explosively upward with your legs to launch the dumbbells off your shoulders.
  5. Punch your arms straight up while dropping into a partial squat (push jerk) to catch both dumbbells locked out directly over your shoulders, then stand all the way up with hips and knees extended to finish the rep. Starting the first rep straight from the floor without pausing at the hang, or lowering the bells before standing up from the jerk, is a no-rep.

Breathing & Bracing

  • Inhale as you hinge the dumbbells down into the hang and brace your abs before snapping your hips open.
  • Let out a short breath as the dumbbells land on your shoulders, then quickly re-brace your belly for the jerk dip.
  • Exhale at the top once your arms are locked out and your legs stand tall, then inhale as the bells come back down to your shoulders and waist.

Keeping It Safe

  • Bicep and elbow strain on the clean: Treating the hang clean like a heavy reverse bicep curl without using your hips will fry your elbows and forearms fast. Let your hip pop launch the dumbbells weightless to your shoulders while your arms simply guide them.
  • Lower back fatigue from swinging too low: Letting the dumbbells pull your chest toward the floor between your legs rounds your lumbar spine. Keep your chest proud during the backswing and stop the hinge around knee level.
  • Shoulder instability overhead: Letting the dumbbells drift wide or out in front of your face during the jerk puts awkward torque on your shoulder joints. Punch your biceps right next to your ears with palms facing each other and ribs pulled down.

Common Fixes

  • Dipping forward on the jerk: When the front heads of the dumbbells tip down on your shoulders, they pull your chest forward during the dip and send the weights out in front of you. Keep your elbows slightly up in the front rack so your dip stays vertical.
  • Turning the jerk into a tiring push press: Forgetting to re-bend your knees after driving the dumbbells off your shoulders forces your triceps and delts to press the final six inches out under fatigue. Practice dropping two inches under the bells at the exact moment your arms lock out.
  • Bruising your shoulders on the way down: Dropping the dumbbells straight from overhead to your thighs can yank your shoulders, while crashing them onto your collarbones hurts. Absorb the weights softly on your shoulders with a slight knee bend, then guide them down to your hips into the next hang.

Scaling & Variations

  • Beginners or shoulder limitations: Drop down to lighter dumbbells so you can nail the timing of the hip pop and second dip, or perform single-arm dumbbell hang clean and jerks (alternating every 5 reps) which require less double-shoulder mobility overhead.
  • Making it harder: Perform unbroken touch-and-go sets with heavy 50/35-pound or 70/50-pound dumbbells, or upgrade to full dumbbell hang squat cleans + split jerks for a demanding coordination and stability test.