• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Double Kettlebell Deadlift

W
Deadlifts
Level: Average

The double kettlebell deadlift lets you pull two independent weights from the floor using either a traditional or sumo stance. It builds thick hamstrings, glutes, inner thighs, and upper-back strength while sparing your lower spine the forward shear of a barbell.

Kettlebell

Description

When a straight barbell bothers your lower back or you want to build serious hip power with a more natural hand position, grab two kettlebells. Because the bells sit right between your feet or right alongside your ankles, the weight starts directly in line with your center of gravity instead of out in front of your shins. That makes the double kettlebell deadlift a go-to builder for posterior chain strength and high-rep conditioning.

The movement is a pure hip hinge with a strong leg push off the floor. Your hips shift backward to load your hamstrings and glutes, and your spine stays neutral from your tailbone to the back of your head. Since you're holding two separate handles, each arm and shoulder blade has to stabilize its own load without the other side helping out.

Your glutes, hamstrings, and inner thighs (adductors) drive your hips forward to stand the weight up. Your quads help break the bells off the floor, while your spinal erectors keep your trunk rigid under load. Up top, your traps, lats, rhomboids, rotator cuff, and forearms lock the handles in place so your shoulders don't get yanked forward at the bottom.

Setup

  • Place two kettlebells side by side on the floor and step up so the handles sit right between your ankles. Most lifters use a slightly wider than hip-width stance with the bells between the feet, though you can also set the bells just outside your feet like a trap bar.
  • Point your toes out 10 to 20 degrees so your knees can track cleanly in line with your feet.
  • Push your hips straight back until your hands reach the handles, then bend your knees slightly to lock in your starting posture with your hips sitting between your knees and shoulders.
  • Grip both handles firmly, twist your elbows in toward your ribs to engage your lats, and look at the floor about six feet ahead.

The Lift

  1. Take the slack out of your arms by pulling your shoulder blades back and down until you feel tension through your hamstrings and glutes.
  2. Push your feet straight down into the floor to lift both kettlebells cleanly off the ground without letting your hips shoot up first.
  3. Keep the bells tracking straight up along your midline as your knees and hips extend at the same rate.
  4. Drive your hips forward and squeeze your glutes hard at the top until you're standing completely tall with your knees locked and shoulders stacked over your hips.
  5. Push your hips back first to lower the bells under control along the exact same vertical path until they tap the floor cleanly between your feet.

Breathing & Bracing

  • Take a big belly breath at the bottom before you pull, expanding your abs, obliques, and lower back 360 degrees.
  • Hold that brace all the way to lockout, then either reset your breath at the top or hold it as you hinge back down to the floor.
  • In fast conditioning sets, exhale briefly at the top of each rep and snap a fresh breath into your belly before lowering the bells.

Keeping It Safe

  • Lower back rounding at the bottom: Kettlebell handles sit lower to the floor than a standard barbell with 45-pound plates. If your hamstrings are tight and your lower back rounds just to reach the handles, elevate the bells on two rubber mats or bumper plates.
  • Pinching fingers between the bells: When pulling between your legs in fast touch-and-go sets, the two kettlebell bodies can clank together and smash your knuckles. Angle the handles slightly in a V-shape or keep firm outward tension on your arms so the bells don't collide.
  • Hyperextending at lockout: Leaning way back at the top doesn't make the rep count more, it just jams your lumbar spine. Stand tall and finish the lift by squeezing your glutes and quads.

Common Fixes

  • Squatting the hinge: Dropping your butt straight down like a deep squat shifts the load off your hamstrings and makes your knees travel too far forward. Think about closing a car door with your butt as you reach back for the handles.
  • Letting shoulders round forward: Heavy kettlebells will pull your shoulder blades apart if your upper back goes lazy. Pretend you're squeezing an orange in each armpit before the bells leave the floor.
  • Bouncing the bells in metcons: Slamming cast-iron kettlebells into the floor for speed wrecks your rhythm and pulls you out of position. Control the eccentric phase and tap the base of the bells smoothly to the mat.

Scaling & Variations

  • Limited mobility or beginners: Set both kettlebells on a pair of 25-pound or 45-pound bumper plates to raise the starting height, or start with a single heavy kettlebell between your feet.
  • Making it harder: Stand on a 2-inch plate for deficit double kettlebell deadlifts, add a 3-second eccentric lower on every rep, or perform suitcase-style deadlifts with the bells outside your feet and a two-second pause an inch off the floor.