• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Dip Bar L-Sit

G
Static
Level: Lung

The dip bar L-sit is a classic gymnastics static hold that builds serious core compression and pressing stability. Locking your arms out on parallel bars while holding your straight legs at a 90-degree angle torches your abs, hip flexors, quads, and triceps with zero swinging allowed.

Dips, Parallettes

Description

Static holds don't get much more honest than the dip bar L-sit. Because the bars are bolted down, you don't have to fight the wobble of gymnastics rings, which lets you put 100 percent of your effort into keeping your legs up and your shoulders tall. It builds the abdominal compression and straight-arm strength that carry directly over to toes-to-bar, parallette handstands, and strict dips.

To hold the L-shape, you push straight down into the bars to lock your elbows and depress your shoulder blades. Your hips shift slightly back between your hands while your legs extend straight out in front of you, parallel to the floor. Everything from your shoulders to your toes has to stay tight as a single unit.

Your rectus abdominis, obliques, and deep transverse abs fire hard to keep your torso upright and your pelvis tucked. Your hip flexors and quads work together to hold the weight of your legs against gravity and keep your knees locked. Up top, your triceps, front and side delts, chest, and lower traps press your body up so you don't sink into your shoulders.

Setup

  • Stand between a set of parallel dip bars (or step up onto parallettes) and grip the bars firmly with neutral wrists right under your shoulders.
  • Jump or press up to a straight-arm support with your elbows completely locked out.
  • Push down hard through your palms to drive your shoulders down away from your ears, keeping your chest up and neck long.
  • Squeeze your legs and heels together before you start lifting.

The Hold

  1. Brace your abs and smoothly raise your straight legs up in front of you without swinging your torso back and forth.
  2. Stop when your legs hit horizontal, forming a clean 90-degree angle with your upright torso.
  3. Lock your knees completely and point your toes forward (or pull them back toward your shins) to keep full tension through your legs.
  4. Keep pushing your shoulders down into the bars. If your heels drop below hip height or your knees bend to take load off your core, that time doesn't count.
  5. Hold the position cleanly for your target seconds, then lower your legs slowly back to the starting support.

Breathing & Bracing

  • Don't hold your breath until your face turns purple. Take quick, shallow sips of air into your chest while keeping your stomach muscles locked tight.
  • Pull your lower ribs down toward your hips to create a tight front brace that supports your lower back and hip flexors.
  • If you're accumulating 60 seconds in a workout, break your holds into crisp 15-second sets before your form turns into a sloppy knee tuck.

Keeping It Safe

  • Shoulder shrugging and neck pain: Letting your body sink between your arms jams your shoulders into your ears and strains your upper traps and rotator cuff. Think about growing as tall as possible through the crown of your head and end the set if your shoulders collapse.
  • Wrist soreness: Leaning too far forward or letting your wrists bend awkwardly on thick bars can irritate your wrist joints. Keep your knuckles stacked straight over the bars and squeeze the handles tight.
  • Lower back arch: If your abs give out while your hip flexors keep pulling on your spine, your lower back will arch hard and ache afterward. Keep your pelvis tucked slightly under and scale to a tuck hold the second your back starts bowing.

Common Fixes

  • Hip flexors cramping immediately: Most lifters have stiff hamstrings and weak hip flexors, so their quads seize up five seconds into the hold. Stretch your hamstrings before class and practice seated pike leg lifts on the floor to build endurance in that top range.
  • Bending the knees: Even a slight knee bend shortens the lever and makes the hold way easier, cheating the movement standard. Straighten your legs completely and squeeze your kneecaps up toward your hips.
  • Leaning the torso backward: Tilting your chest back opens up the hip angle and turns the L-sit into a lazy lean. Shift your hips slightly back between your hands while keeping your chest vertical over the bars.

Scaling & Variations

  • New athletes: Start with a two-legged tuck hold by bringing your knees up to hip height with bent legs. Once you own a 30-second tuck, extend one leg out straight and swap legs halfway through the set.
  • Making it harder: Move the L-sit down to floor parallettes or flat palms on the floor, or lift your feet higher toward a V-sit to demand even more compression from your abs and hip flexors.