• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Clean Extension

W
Deadlifts
Level: Average

Pull a heavy barbell from the floor using exact clean mechanics and finish with an explosive triple extension and shrug at the top while keeping your arms straight. The clean extension builds massive leg drive, back strength, and bar-path discipline for heavier cleans.

Barbell

Description

When your clean stalls at heavy weights, the problem usually starts in the first or second pull. The clean extension (often called a clean pull to the hip) isolates the exact positions of a full clean from the floor through complete triple extension and shoulder shrug, without bending your elbows or dropping under the bar. Because you don't have to catch the weight, you can load the bar past your 1RM clean to overload your legs, hips, and traps while grooving a vertical bar path.

Unlike a standard deadlift where your hips are higher and your shoulders sit further ahead of the bar, the clean extension starts with a lower hip position and a more upright chest. You push through the floor with your legs while keeping your back angle constant until the bar clears your knees. Once the bar sweeps up to your upper thighs, you explode straight upward through your hips, knees, and ankles, shrugging your shoulders hard at the top while keeping your arms completely long and relaxed like straps.

Your quads, glutes, and hamstrings generate the upward force off the floor and through the explosive hip drive. Your calves fire at the finish to push you up onto the balls of your feet, while your traps and rhomboids power the violent shrug at the top. Throughout the pull, your spinal erectors, lats, abs, obliques, and forearms work isometrically to lock your spine in neutral and keep the bar glued to your legs.

Setup

  • Stand with your feet hip-width apart and the barbell directly over the middle of your feet, about an inch from your shins.
  • Squat down and grip the bar just outside your legs using a hook grip (thumbs wrapped under your index and middle fingers).
  • Set your hips higher than your knees but lower than your shoulders, pull your chest tall, and turn your elbows out toward the plates so your arms stay long.
  • Sweep the bar back against your shins by engaging your lats, and fix your eyes on a spot straight ahead.

The Pull

  1. Push the floor away with your legs like a leg press, lifting the bar smoothly off the platform while keeping your back angle unchanged from the floor to your knees.
  2. Shift your balance slightly toward midfoot as your knees move back slightly, clearing a straight vertical path for the bar.
  3. Sweep the bar tightly up your thighs with your lats keeping your shoulders slightly in front of the bar until it reaches your upper thighs (the power position).
  4. Drive your legs hard through the floor to violently extend your hips, knees, and ankles straight upward, allowing the bar to brush your upper thighs without banging it forward.
  5. Shrug your shoulders straight up toward your ears as your heels rise off the floor, keeping your arms completely straight before lowering the bar under control back to the platform.

Breathing & Bracing

  • Take a deep belly breath at the bottom before the bar leaves the floor, bracing your core 360 degrees.
  • Hold that breath and internal pressure through the first pull and the explosive extension at the top so your spine stays rigid under supramaximal loads.
  • Exhale only after the bar returns to your thighs or the floor, resetting your brace before the next rep.

Keeping It Safe

  • Lower back rounding: Letting your hips shoot up first off the floor turns the movement into a stiff-legged deadlift and overloads your lumbar discs. Push with your quads off the ground so your hips and shoulders rise at the exact same rate.
  • Bicep tendon strain: Bending your elbows early to yank the bar up with your arms under 100-plus percent clean loads can tear a bicep tendon. Keep your triceps lightly flexed during the first pull so your arms stay straight like steel cables.
  • Bruised pubic bone or thighs: Humping the bar horizontally with your hips slams the steel into your pelvis and loops the bar away from you. Think about jumping straight up through the ceiling rather than thrusting your hips forward into the bar.

Common Fixes

  • Hips rising too fast off the floor: When the weight feels heavy, lifters panic and strip their knees back early, leaving their chest pointed at the floor. Pause for 2 seconds one inch off the ground in warm-ups to make sure your chest and hips move together.
  • Bending the arms at the top: Turning a clean extension into an arm-heavy upright row ruins the timing of the finish. Focus solely on driving with your legs and shrugging your traps while your hands simply hang on.
  • Rushing off the floor: Ripping the bar off the ground yanks your upper back loose and pitches you onto your toes before the bar even reaches your knees. Build tension against the bar first, push smoothly past your knees, and save maximum speed for the top of the thigh.

Scaling & Variations

  • Beginners or grip fatigue: Use lifting straps on heavy sets past your max clean so grip strength doesn't limit your leg drive, or start with lighter paused clean deadlifts (stopping at the knee) to learn the positions.
  • Making it harder: Pull from 2-inch risers (deficit clean extensions) to build strength off the floor, or add a 3-second eccentric lowering phase from the hip down to the platform.