• En
  • kg/m
  • Timer
  • Software
  • Feedback

v2.10.89PRO

By using our site, you confirm that you have read and agree to our Cookie Policy, Privacy Policy, and our Terms of Service. It is also necessary for the normal functioning of this site. WODCAT is not affiliated with CrossFit, Inc. in any way. CrossFit is a registered trademark of CrossFit, Inc.

Back Extensions

G
Hyperextension
Level: Lung

Back extensions are a bodyweight posterior chain movement typically performed on a Glute Ham Developer (GHD) or Roman chair. By hinging at the hips or flexing and extending the spine under control, you strengthen your glutes, hamstrings, and spinal erectors to build a resilient lower back for heavy pulls and squats.

Description

A weak posterior chain will hold back your deadlift, Olympic lifts, and long barbell workouts faster than almost anything else. Back extensions give you a direct way to target the entire back side of your body without crushing your spine under a heavy barbell. Depending on how you set the pads and whether you keep your back flat (hip extension) or articulate your spine vertebra by vertebra (true back extension), you can train both hip drive and spinal endurance.

When you perform the standard CrossFit GHD hip-and-back extension, your pelvis rests right on the edge of the front pad so your hips can hinge freely toward the floor. As you lower your torso to a 90-degree angle, your hamstrings and glutes lengthen under tension while your knees stay straight. Driving your thighs into the pad reverses the movement, bringing your torso back up to a horizontal line with your legs.

Your glutes and hamstrings act as the primary engines here, pulling your pelvis back into extension as you rise. Your spinal erectors work hard to either hold your trunk rigid from hip to head or extend your spine segment by segment if you're doing strict segmental back extensions. Meanwhile, your calves push your heels against the footplates to anchor your lower body, and your abs and obliques brace your midline so you don't hyperextend at the top.

Setup

  • Adjust the GHD footplate so that when your ankles are hooked in the rollers, your hip crease sits just past the front edge of the main pad. If the pad blocks your thighs, you won't be able to hinge properly.
  • Step into the machine carefully, lock your feet between the rollers with your toes pointed down, and support yourself on the handlebars before lowering into position.
  • Cross your arms over your chest or place your fingertips lightly behind your ears with your elbows pulled back.
  • Start in a horizontal plank position facing the floor, with your knees straight, glutes squeezed, and neck neutral.

The Movement

  1. Brace your abs and hinge at your hips, lowering your torso smoothly toward the floor while keeping your knees locked out.
  2. Descend until your torso hangs roughly perpendicular to the floor and your head points toward the ground. Keep tension in your hamstrings at the bottom rather than relaxing completely.
  3. Drive the front of your thighs into the pad and squeeze your glutes and hamstrings to pull your torso back up.
  4. Keep your chin tucked slightly so your neck stays in a straight line with the rest of your spine.
  5. Finish the rep as soon as your torso reaches a straight, horizontal line parallel to the floor. Arching way past parallel doesn't build more strength, and cutting the range short at the bottom or top is a no-rep. Aim for a smooth 2-second descent and a controlled 1-to-2-second rise.

Breathing & Bracing

  • Inhale through your nose as you hinge down toward the floor, maintaining mild tension across your stomach so you don't collapse at the bottom.
  • Brace your abs and glutes right before you reverse direction at the bottom of the hang.
  • Exhale as you rise back to horizontal, keeping your ribs pulled down at the top so your lower back stays flat instead of overarching.

Keeping It Safe

  • Lower back pinching: Happens when athletes yank their chest up way past parallel at the top, jamming their lumbar vertebrae together. Stop every rep the instant your shoulders, hips, and heels form a straight horizontal line, and squeeze your glutes to lock in that finish.
  • Hamstring cramps or pulls: Locking your knees too aggressively when your hamstrings are cold can trigger a nasty cramp on the GHD. Warm up with light good mornings or glute bridges first, and keep a tiny, athletic micro-bend in your knees if your hamstrings are super tight.
  • Dizziness from inversion: Hanging upside down for 25 fast reps can make your head spin when you hop off the machine. Keep your gaze neutral rather than whipping your head up and down, and take two seconds on the support handles before stepping off the GHD.

Common Fixes

  • Pad set too far forward on the belly: If the pad sits under your stomach instead of your hips, your pelvis can't hinge and your lower back takes 100 percent of the bending load. Move the footplate one or two holes closer to the pad so your hip bones clear the edge.
  • Using momentum and swinging: Dropping to the bottom and bouncing out of the hang turns the exercise into a lower-back whip. Pause for one full second at the bottom of each rep to force your hamstrings and glutes to do the actual work.
  • Bending the knees to cheat the pull: Turning the movement into a mini-GHD hip-and-knee bend takes the stretch off the hamstrings. Focus on pressing your heels back against the top roller to keep your legs long.

Scaling & Variations

  • No GHD or lower back sensitivity: Perform floor Superman holds, glute bridges, or 45-degree Roman chair hip extensions where the angle is less demanding. You can also shorten the range of motion on the GHD until your lower back adapts.
  • Making it harder: Extend your arms straight overhead in a streamline position to lengthen the lever, pause for 2 seconds at the horizontal top of every rep, or transition to weighted GHD extensions holding a bumper plate or barbell when programmed.